Sanyo VPC-C1EX Camcorder User Manual


 
English
136
Changing the remote control code
The remote control unit will also work with other Sanyo cameras that can be
operated by infrared remote control. When more than one camera is
present, it is recommended to change the remote control code to ensure that
only the intended camera operates when the remote control unit is used.
The remote control code is set to RC CODE 1 at the time of purchase.
<Changing the remote control code from RC CODE 1 to RC
CODE 2>
1
Aim the infrared emitter at the remote control sensor on the docking
station.
2
Hold down the CH button and press the [I] button for about 3
seconds.
3
Press a button on the remote control unit and check that the camera
is receiving correctly.
e The remote control codes are retained even if the batteries in the
remote control unit and camera are replaced.
e If the remote control codes for the remote control unit and the camera
and do not match, the remote control unit cannot be used to operate
the camera.