Filter
Top Products
English 114
5 Specify the start point of the extract.
h Use the procedure below to specify the frame from which the video
clip extract will start.
h Play the video clip until approximately the desired point, pause the
video clip, then play the video clip one frame at a time, stopping at the
start point of the extract. This will be the first frame of the extract.
h If the start point of the video clip is also the start point of the extract,
proceed to step 6.
<Procedure>
Play:
After pausing playback, press and hold the SET button to the right for
about 2 seconds for forward playback, or to the left for reverse
playback.
Pause:
During playback, press the SET button.
Accelerated playback:
During playback, toggle the SET button to the left or right to change
the playback speed.
Single frame:
After pausing playback, toggle the SET button to the right to move
forward one frame, or to the left to move back one frame.
6 Toggle the SET button up.
h The start point of the video clip
extract is set, and the screen to
specify the end point appears.
h Specify the end point of the extract
by following the same procedure as
in step 5.
<When joining the first and latter
portions>
1 Toggle the SET button down.
h Each time the SET button is
toggled down, the sections to
delete and the sections to save
are reversed.
2 Specify the end point of the
extract. The frame following the
end point of the extract will be the
start point of the latter portion to be
joined.
Press shutter to save
00:01:10
CUT
End point
Portion to be deleted
Approximate playback time