18
Using the components
Switching the components on/off
ew 300 G2 transmitters and receivers can only be switched off when the
standard display is shown on the display panel. Within the operating menu,
the ON button (receiver) or the ON/OFF button (transmitters) serves as the
ESC (cancel) key, i.e you cancel your entry and return to the standard display.
Note:
Remove the batteries or the accupack when the units will not be used for
extended periods of time.
Switching the rack-mount receiver on/off
̈ Press the ON button ¿ to switch the receiver on.
̈ To switch the receiver off, press the ON button until “OFF” appears on the
display.
Switching the bodypack transmitter on/off
̈ Press the two unlocking buttons µ and open the battery compartment
cover ¾.
̈ Press the ON/OFF button ² to switch the bodypack transmitter on. The
red LED » lights up.
̈ To switch the bodypack transmitter off, press the ON/OFF button ¸ until
“OFF” appears on the display. The red LED » goes off.
̈ Close the battery compartment. The battery compartment cover ¾ locks
into place with an audible click.
Switching the radiomicrophone on/off
̈ Turn the protective cap ¶ at the bottom of the radiomicrophone so that
the ON/OFF button ¹ becomes accessible.
̈ Press the ON/OFF button to switch the radiomicrophone on. The red
LED ¸ lights up.
̈ To switch the radiomicrophone off, press the ON/OFF button ¹ until
“OFF” appears on the display. The red LED ¸ goes off.
¿
µ
¾
¸
»
¶
¹
¸