Filter
Top Products
21
Working with the operating menu
By way of example of the “Tune” menu, this section describes how to use the
operating menu.
After switching the unit on, the standard display is shown on the display
panel.
Getting into the operating menu
̈ Press the SET button to get from the standard display into the operating
menu. The last menu selected flashes on the display. With the receiver,
the current setting is additionally displayed.
Selecting a menu
̈ Press the ̆/̄ buttons to select a menu.
̈ Press the SET button to get into the setting mode of the selected menu.
With the transmitters, the current setting that can be adjusted flashes on
the display. With the receiver, the name of the menu and the current
setting are displayed.
Adjusting a setting
̈ Press the ̆/̄ buttons to adjust the setting.
By briefly pressing the ̆/̄ buttons, the display jumps either forwards or
backwards to the next setting. In the “Channel”, “Tune” and “Name”
menu, the ̆/̄
buttons feature a “fast search” function. If you hold down
a button, the display cycles continuously. The “fast search” function
allows you to get fast and easily to your desired setting. With the
transmitters, the new setting flashes on the display until it is stored.
Storing a setting
̈ Press the SET button to store the setting. “Stored” appears on the display,
indicating that the setting has been stored. The display then returns to
the top menu level.
With most menus, new settings become effective immediately without
having to be stored. An exception are the “BANK”, “CHAN”, “TUNE” and
“RESET” menus of the transmitters and the “Reset” menu of the receiver.
With these menus, new settings only become effective after they have
been stored and “Stored” had appeared on the display.
EM 300 G2
Transmitters