Sharp VL-NZ100U Camcorder User Manual


 
Basic Operations
Camera Recording
Basic Operations
23
Tape Playback
Available mode:
TAPE-VCR
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be
connected, allowing instant on-screen play-
back with the sound through the built-in
speaker.
1 Set the Media Selection
switch to TAPE.
2 Hold down the Lock button
and set the Power switch to
VCR.
3 Press j (or k) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
4 Press m to begin playback.
Note:
• If you press the REC START/STOP button in
TAPE-VCR mode, the “ ” mark appears and
the camcorder enters Recording Standby mode.
If you do not intend to record, press l to turn
the “ ” mark off, then press m to begin
playback. This will ensure your previous
recording is not erased (see pages 49, 51).
Basic Operations
Playback
To stop playback
Press l.
VOLUME
Volume Control
Available mode:
TAPE-VCR
When the camcorder is in TAPE-VCR mode,
push the Volume control to the L or + side to
increase (1) or decrease (2) the volume.
The volume level indicator will appear on the
LCD screen during adjustment only. Once the
Volume control is released, the volume level
indicator will disappear shortly afterwards.
To turn the power off
Set the Power switch to OFF without pressing
the Lock button.
Note:
• The tape is automatically rewound when
playback reaches the end of the tape.
Volume control
Decrease
Increase
Lock button
Operation button
Media Selection switch
Power switch
Speaker