Sharp VL-NZ100U Camcorder User Manual


 
Advanced Features
50
Using the Camcorder as
a Converter
Available mode:
TAPE-VCR
You can use this camcorder to convert from
analog signal (e.g. video recorded on 8 mm or
Hi8 tapes) to digital signal.
Connect the audio/video cable and DV cable
as shown below.
1 Set the camcorder to TAPE-VCR mode,
and make sure that playback stops.
2 Press the MENU button to display the
menu screen.
3 Press l or m on the operation button
to select V, then press the SET button.
4 Press l or m to select “ANLGnDGTL”,
then press the SET button.
5 Press l or m to select “ON”, then press
the SET button.
6 Press the MENU button to turn off the
menu screen.
7 Press the Play button on the analog
equipment
Check the monitor on the digital
equipment to see if the picture is being
properly received.
8 Press the Record button on the digital
equipment.
Notes:
• The camcorder is not guaranteed to work with all
digital/analog equipment. Contact the manufac-
turer of your equipment for advice.
• If the camcorder outputs a video recording with
a copyright signal, the digital equipment cannot
record or save it.
• The camcorder may not convert some input
video recordings properly (e.g. discoloration,
picture noise, muted sound), depending on the
input condition.