Filter
Top Products
Preparation
11
Installing the Battery to
Remote Control (Not sup-
plied)
The remote control (RRMCGA237WJSA)
is not supplied with this camcorder.
Contact the nearest SHARP service
centre or your dealer for purchasing as
specified part.
The CR2032 type lithium battery is used
to power the remote control unit.
1 Insert a pointed object such as the
tip of a ballpoint pen to open the
battery holder.
2 Place the CR2032 type lithium
battery on the battery holder with the
H side facing down.
3 Close the battery holder until it
clicks.
Notes on the Use of the Lithium
Battery
• Do not short-circuit, recharge, disassemble,
or heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment clean, and then insert a
new battery.
• The lithium batteries will last about one year
under normal usage.
CAUTION: Danger of explosion if
battery is incorrectly replaced. For
camcorder, replace only with same or
equivalent type CR1216, for remote
control unit, replace only with same or
equivalent type CR2032, both recom-
mended by the equipment manufac-
turer.
X KEEP THIS BATTERY
AWAY FROM CHILDREN. IF SWAL-
LOWED, CONSULT A PHYSICIAN
IMMEDIATELY FOR EMERGENCY
TREATMENT.
Z BATTERY MAY EXPLODE
IF MISUSED OR INSTALLED WITH
POLARITY REVERSED. DO NOT
RECHARGE, DISASSEMBLE OR
DISPOSE OF IN FIRE.
CR2032 type lithium battery
VL-Z300E/VL-Z100E-E-005-019 04.2.16, 8:30 AM11