Filter
Top Products
24
[a] [b]
— Playback – Basics —
Playing back a tape
You can monitor the playback picture on the LCD screen or in the viewfinder. If you
close the LCD panel, you can monitor the playback picture in the viewfinder. You can
control playback using the Remote Commander supplied with your camcorder.
(CCD-TRV57/TRV67/TRV87 only)
(1) Install the power source and insert the recorded tape.
(2) Set the POWER switch to VTR (CCD-TRV87) or PLAYER (CCD-TRV17/
TRV37/TRV57/TRV67) while pressing the small green button.
(3) Open the LCD panel while pressing OPEN.
(4) Press m to rewind the tape.
(5) Press N to start playback.
(6) To adjust the volume, press either of the two buttons on VOLUME. The
speaker on your camcorder is silent when the LCD panel is closed.
To stop playback
Press x.
When monitoring on the LCD screen
You can turn the LCD panel over and move it back to the camcorder body with the LCD
screen facing out [a]. You can adjust the angle of the LCD panel by lifting the LCD
panel up by 15 degrees [b].
3
5
PLAY
4
REW
2
6
VOLUME
POWER
OFF
VTR
CAMERA
(CHARGE)
15°