Sony DCR-DVD7 Camcorder User Manual


 
18
DCR-DVD7
2-597-462-11(1)
Step 2: Charging the battery pack (continued)
6 Connect the AC Adaptor to the
wall outlet using the power cord.
The CHG (charge) lamp lights up and
charging starts.
7 The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor
from the DC IN jack on your
camcorder.
Disconnect the AC Adaptor holding
both your camcorder and the DC plug.
To remove a battery pack
Slide the battery cover OPEN switch in the
same way as when installing a battery pack.
After opening the battery cover, pull the
battery pack out.
When you remove the battery pack, make
sure that none of the respective lamps of the
POWER swtich is on.
When storing the battery pack
Use up the battery pack completely if you
do not intend to use it for a long time (p.
99).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Charging time (full charge)
Approximate charging time (min.) required
when you fully charge an empty battery
pack.
Battery pack Charging time
NP-FA50 (supplied) 125
NP-FA70 155
Recording time
Approximate time (min.) available when
you use a fully charged battery pack.
Battery pack
Continuous
recording time
Typical
recording time
NP-FA50
(supplied)
90
100
40
45
NP-FA70
170
190
80
90
If you record under the following conditions:
Top: When the LCD backlight is on
Bottom: When the LCD backlight is off
Playback time
Approximate time (min.) available when
you use a fully charged battery pack.
Battery pack
LCD screen
backlight on
LCD screen
backlight off
NP-FA50
(supplied)
100 115
NP-FA70 190 215