Filter
Top Products
62
Frame by frame recording – Cut recording
You can make a recording with a stop-motion animated effect using cut recording. To
create this effect, alternately move the subject a little and make a cut recording. We
recommend that you use a tripod, and operate the camcorder using the Remote
Commander after step 4.
(1) In standby mode, press FN to display PAGE1.
(2) Press MENU, then set FRAME REC to ON in
in the menu setting (p. 105).
(3) Press EXIT to return to FN.
The FRAME REC indicator lights up.
(4) Press START/STOP to start cut recording. The camcorder makes a recording
for about six frames, and returns to recording standby.
(5) Move the subject, and repeat step 4.
To cancel the cut recording
Perform either of the following:
–Set FRAME REC to OFF in the menu settings.
–Set the POWER switch to other than CAMERA mode.
Note
The proper remaining tape time is not indicated if you use this function continuously.
When using the cut recording function
The last recorded cut is longer than other cuts.
1
FN
2
CAMERA SET STBY
D ZOOM
16 : 9WIDE
STEADYSHOT
N. S. LIGHT
FRAME REC
INT. REC
EDITSEARCH
EXIT
RET.
EXEC
OFF
ON