Filter
Top Products
Chapter 2 Locations and Functions of Parts and Controls 2-21
2
OUTPUT / DCC selector
!¢ GAIN selector
This selector switches the gain of the video amplifier to match the
lighting conditions during shooting. The gains corresponding to the L,
M, and H settings are selected from the setup menu before use. The
factory settings are L = 0 dB, M = 9 dB, and H = 18 dB.
Note that if the display mode is set to 3 when this selector is adjusted, the
new setting will be indicated on the setting change / adjustment progress
message display area of the viewfinder screen for about 3 seconds (e.g.
GAIN : 12 dB).
For information about setting the gain values, see Section 4-9-1 “Setting the GAIN
Selector Values” (page 4-67).
BARS, DCC OFF
An SMPTE type (for the DVW-700) or EBU
type (for the DVW-700P) color bar signal is
output and the DCC circuit does not
operate. For example, use the setting for
the following purposes.
• Adjusting the video monitor
• Recording the color bar signal
CAM, DCC OFF
The video signal from the camera
is output and the DCC circuit does
not operate.
CAM, DCC ON
The video signal from the camera
is output and the DCC circuit
operates.