Filter
Top Products
Chapter 4 Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus 57
Structures and setting values of the USER menu
Submenu title Page Setting item: Selectable Remarks
Initial value value
<USER PAGE 1> U1 A.IRIS OVERRIDE: 0 –99 to 0 to 99 To adjust the reference value for auto aperture
DTL LEVEL: 0 –99 to 0 to 99 To adjust the detail (contour correction) level
MASTER BLACK: 0 –99 to 0 to 99 To adjust the master black level
PRESET MATRIX: STD STD, HI SAT, To adjust the preset matrix
FL STD: Standard color tone
HI SAT: For more vivid picture (The color
intensity increases a little.)
FL: For shooting under fluorescent light, to
prevent the skin color’s becoming greenish
SCREEN MODE: 16:9 16:9, 4:3 To select the aspect ratio of the output signal
<USER PAGE 2> U2 SCENE STANDARD: — To select if the standard settings are to be used
EXECUTE or not
SCENE FILE 1 — To read a scene file set with the FILE menu.
SCENE FILE 2 —
(For details on settings, see “FILE menu” on
SCENE FILE 3 —
page 70.)
SCENE FILE 4 —
SCENE FILE 5 —
<USER PAGE 3> U3 SKIN DTL SW: OFF ON, OFF To turn skin tone detail on/off
SKIN DTL SET: — To execute the skin set (The box cursor
EXECUTE appears at the center of the screen. Move the
cursor to where you wish to execute the skin set
by turning the MENU dial, then press it to
execute the skin set. For about 3 seconds after
the MENU dial is pressed, a zebra pattern will
be displayed to indicate the location where the
skin tone is activated.)
SKIN DTL LEVEL: 50 0 to 50 to 99 To adjust the detail level when skin-tone detail
is set to ON. At 99, the maximum effects are
obtained.
<USER PAGE 4> U4 SAFETY ZONE SW: ON ON, OFF To turn the safety-zone display on/off
CENTER MARKER SW: ON, OFF To turn the center marker on/off
ON
<USER PAGE 5> U5 SC PHASE: 0 0 to 999 To adjust the SC phase (Setting when gen-
locked)
H PHASE COARSE: 0 –99 to 0 to 99 To adjust the horizontal phase (Setting when
gen-locked)
H PHASE FINE: 0 –99 to 0 to 99 To fine-adjust the horizontal phase (Setting
when gen-locked)
USER Menu
The USER menu consists of five pages (factory
setting), on which frequently used items of the
OPERATION, PAINT, MAINTENANCE, and FILE
menus are assigned. You can change the assigned
items using the USER MENU CUSTOMIZE menu.
<USER PAGE 1> U1
A.IRIS OVERRIDE : 0
DTL LEVEL : 0
MASTER BLACK : 0
PRESET MATRIX : STD
SCREEN MODE : 16:9