Filter
Top Products
14
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (H series) (p. 95) after
attaching it to your camcorder.
b Notes
• You cannot attach any “InfoLITHIUM” battery
pack other than the H series to your camcorder.
1 Attach the battery pack to your
camcorder.
Attach the battery pack by sliding it in
the direction of the arrow until it clicks.
2 Slide the POWER switch to OFF
(CHG) (the default setting).
3 Connect the AC Adaptor to the
DC IN jack of your camcorder. Be
sure that the v mark on the DC
plug is facing to the v mark on
your camcorder.
4 Connect the power cord to the AC
Adaptor and the wall outlet.
The /CHG (charge) lamp lights up and
charging starts. The /CHG (charge)
lamp turns off when the battery is fully
charged.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
z Tips
• You can operate your camcorder connected to a
power source such as a wall outlet as shown in
the illustration. The battery pack will not lose its
charge in this case.
1
2
4
3
4
Battery pack
To the wall outlet
Power cord
AC Adaptor
/CHG
(charge)
lamp
DC IN jack
POWER
switch
DC plug