Filter
Top Products
Chapter 10
Setup Menus
Chapter 10
Setup Menus 10-25
Menu items in the range 700 to 799, relating to video control (Continued)
(Items 715 to 720: Settings for controlling the SD video processing system according to the menu settings.)
SYSTEM PHASE SC
(Invalid in 24PsF or
23.98PsF mode)
719 SYSTEM PHASE SYNC
(Invalid in 24PsF or
23.98PsF mode)
Adjust the SD output signal sync phase.
0 to 80H to FFH
720 Adjust the SD output signal subcarrier phase.
0 to 3FFH
721 Y/C DELAY
(HDW-M2000/M2000P
only. Invalid in 24PsF or
23.98PsF mode.)
For playback from an analog Betacam cassette, adjust the Y/C delay.
0 to 800H to FFFH
Item number
Item name
715 VIDEO GAIN CONTROL
716 CHROMA GAIN
CONTROL
717 CHROMA PHASE
CONTROL
718 SETUP LEVEL (59.94i,
29.97PsF mode)/BLACK
LEVEL (50i, 25PsF mode)
(Invalid in 24PsF or
23.98PsF mode)
Settings
Adjust the video output level.
0 to 800H to B50H
Note
This item is valid for both HD and SD outputs.
Adjust the chroma output level.
0 to 800H to B50H
Note
This item is valid for both HD and SD outputs.
Adjust the SD chroma phase.
0 to 80H to FFH
Note
This item is valid for both HD and SD outputs.
Adjust the SD setup level (black level).
0 to 110H to 220H
Note
This item is valid for both HD and SD outputs when sub-item (D2 SETUP) of
menu item 212 (VIDEO REMOTE CONTROL SELECT) is set to “black”.
Notes
•When you make settings for menu items 715 to 718
or 740 to 747, set the function menu item V.PROC to
MENU. When it is set to MENU, all controls for
video output processing on the control panel are
disabled.
•When menu item 337 is set to SD, changing the
settings of menu items 719 and 720 changes the
phase of HD output signals as well as that of SD.
After changing the settings, use the F1 (SYNC) and
F2 (SC) items or menu items 745 and 746 on function
menu page 3 to readjust the phase of HD output
signals.
(Continued)