Filter
Top Products
Chapter 5 Connections and Preparations
Chapter 5 Connections and Preparations 5-11
To assign a monitor camera
Set CAM n (MON).
You can specify the camera number by pressing
the corresponding number key. Note, however,
that the camera set to NO in CAMERA
CONNECTION cannot be selected.
Repeat steps 4 and 5 for all the divisions.
The same camera can be assigned to multiple
divisions.
When setting the structure in a dividing mode that
has multiple pages, the setting display for the
subsequent page will appear by pressing the b)
key in the last (lower right) division. To return to
the pervious page, press the B key in the first
(upper left) division.
To set the selected division to a blank (no
display) division
Set to NO.
If all the divisions of a page are set to “NO, ” that
page will be skipped when monitoring. Similarly,
if all the divisions of a dividing structure are set to
“NO,” that dividing structure will be skipped when
monitoring.
6 When the settings are completed, press the SET
key.
A message “NOW SAVING” is displayed and the
settings are stored in nonvolatile memory.
The Image Control Menu is restored.
To restore the previous setting
Before pressing the SET key, press the MENU key.
The message “ABORT !” is displayed, and the
previous setting is restored.
Setting the Automatic Change
Cycle
The picture to be monitored in Full screen
(nondivided) mode can be automatically changed at
the specified cycle.
You can determine whether to automatically change
the picture and, if to change, the cycle independently
for the VIDEO OUT A and B connectors.
The S-VIDEO connector always outputs the same
signal as that from the VIDEO OUT A connector.
Use A IMAGE (A Image) and B IMAGE (B Image) of
the Image Control menu.
The setting procedure is common to the A and B
connectors.
To activate the automatic change function
Set MONITOR (Monitor) of A IMAGE (A Image) or
B IMAGE (B Image) to AUTO (Auto).
1 Highlight IMAGE CONTROL MENU (or display
Image Menu) of the top menu by pressing the V or
v key, then press the b key.
The Image Control menu (page 4-6) is displayed.
2 Highlight A IMAGE or B IMAGE (or display A
Image or B Image) by pressing the V or v key, then
press the b key.
The menu shifts to corresponding setting.
Example: A Image
SETUP MENU
IMAGE CONTROL MENU
A IMAGE
M MONITOR : MANUALm
ALARM CHANGE : OFF
AUTO CYCLE
(Continued)