Filter
Top Products
between the product and the subject, refer to the position of the horizontal line.
The distance from the lens contact surface to the image sensor is about 18 mm (23/32 in.).
*
The image sensor is the part that converts the light source to a digital signal.
Note
If the subject is closer than the minimum shooting distance of the lens, the focus cannot be
confirmed. Make sure you put enough distance between the subject and the product.
How to Use
Using shooting functions Adjusting the exposure
Exposure Comp.
Based on the exposure value set by auto exposure, you can make the entire image brighter or
darker if you adjust [Exposure Comp.] to the plus side or minus side, respectively (exposure
compensation). Normally, exposure is set automatically (auto exposure).
1. MENU → (Camera Settings) → [Exposure Comp.] → desired setting.
You can adjust the exposure in a range of –3.0 EV to +3.0 EV.
Note
You can adjust the exposure in a range of –2.0 EV to +2.0 EV for movies.
If you shoot a subject in extremely bright or dark conditions, or when you use the flash, you
may not be able to get a satisfactory effect.
Only a value between –2.0 EV and +2.0 EV with the equivalent image brightness appears on
the screen when shooting. If you set an exposure beyond this range, the image brightness on
the screen does not show the effect, but it will be reflected in the recorded image.
When you use [Manual Exposure], you can compensate for the exposure only when [ISO] is