Filter
Top Products
26
Troubleshooting
If
you
experience
trouble
with
your
camera,
try
the
following
solutions.
OCheck
the items below, and refer
to "Network Sharing Camera
Handbook" (PDF).
eTurn
the power off, and turn
it
on
again after about one minute.
E)Press
the RESET button using a
fine-tipped object, and turn on the
power.
tlH--+r-
RESET button
OConsult
your Sony dealer or local
authorized Sony service facility.
When
repairing
the
camera,
we
may
check
a
minimum
amount
of
data
stored
on
the
internal
memory
in
order
to
improve
the
condition.
However,
Sony
dealer
will
neither
copy
nor
save
your
data.
lale.
anlllWI~
Cannot turn
on
the camera.
- Remove the insulation sheet.
-
The
battery is discharged. Charge the
battery (page 7).
-
The
plug
of
the AC Adaptor has been
disconnected from the wall outlet
(wall socket). Connect it to the wall
outlet (wall socket) (page 7).
The power turns off suddenly.
•
If
you do not operate the camera for
about three minutes while the power is
on, the camera turns
off
automatically
to prevent wearing down the battery.
Tum
on the camera again (page 9).
The battery remaining indicator is
incorrect.
• This phenomenon occurs when you use
the camera in an extremely hot or cold
location.
• The displayed battery remaining differs
from the current one. Fully discharge
and then charge the battery to correct
the display.
• The battery is discharged. Charge the
battery (page 7).
Your camera cannot record images.
• Check the free capacity
of
the internal
memory
or
"Memory Stick Duo"
(page 25).
If
it is full, do one
of
the
following:
• Delete unnecessary images (page 13).
• Change the "Memory Stick Duo".
• The shooting mode will automatically
stop
in
either
of
the following
situations.
- When the file size
of
the movie being
recorded exceeds 2 GB.
- After the maximum shooting duration
time* for each file has passed.
* NSC-GC I: 2 hours,
NSC-GC3: 29 minutes
• You are using the "Memory Stick Duo"
with the write-protect switch, and the
switch is set to the
LOCK
position. Set
the switch to the recording position.
• You cannot record images whi
Ie
charging the flash .
• Press MODE and set the camera to
recording mode to shoot a movie or a
still image.