Filter
Top Products
Administrating the Camera
Saving the SolidPTZ Display Area and Action — Preset position Menu (SNC-DM110 / DM160 / CM120 only)
58
Up to 16 positions can be programmed, and the display
area moves to the programmed positions sequentially
(Tour).
One PTZ on motion detection and up to four tours
(Tours A to D) can be set.
Display sample: SNC-DM160
Tour
Select On to enable the PTZ on motion detection and
tour function.
Resume time on inactivity
This item becomes active when Tour is set to On.
With this item, you can select whether to restart or stop
the PTZ on motion detection or tour after it has stopped
by manual pan, tilt or zoom operation or by moving the
display area to the preset position triggered by an alarm.
On: Specify the wait time before the PTZ on motion
detection or tour restarts, between
5 and 600 seconds. It restarts automatically after the
specified time has elapsed.
Off: The PTZ on motion detection or tour do not restart.
PTZ on motion detection
Configure the PTZ on motion detection that is
performed in synchronization with the motion detection
function.
This setting consists of two items: On/Off and Effective
period.
On: The PTZ on motion detection operates.
Off: The PTZ on motion detection does not operate.
Click Detection, and the Motion detection menu is
displayed to allow you to set the motion detection
function (page 75).
Effective period
Select the period during which the PTZ on motion
detection is activated.
Always: The PTZ on motion detection can be activated
any time.
Schedule: The PTZ on motion detection is activated
according to the schedule you have set. Click
Schedule, and the menu for the effective period is
displayed. (“Setting the Schedule — Schedule
Menu” on page 73)
Notes
• If no moving objects exist, zoom changes to the WIDE
end automatically and full image is displayed.
• You cannot set the PTZ on motion detection so that its
effective period overlaps those of the tours.
Tour A to Tour D
Configure Tour A to Tour D respectively.
Each tour setting consists of 5 items: On/Off, Effective
period, Stay time, Speed and Sequence.
On: The tour operates.
Off: The tour does not operate.
Effective period
Select the period during which the tour in activated.
Always: The tour can be activated any time.
Schedule: The tour is activated according to the
schedule you have set.
Click Schedule, and the menu for the effective
period is displayed. (“Setting the Schedule —
Schedule Menu” on page 73.)
Note
You cannot set tours so that the effective periods overlap
with the PTZ on motion detection or other tours.
Stay time
Type a period of time during which the display area is to
stay at each preset position, between 1 and 3600
seconds.
Speed
Select the speed of movement between 1 and 23, or
Fastest from the drop-down list. The display area moves
faster with a higher number setting.
Select Jump to move directly to the desired preset
position.
Sequence
Set the sequence of the tour.
The preset positions saved using the Position tab are
displayed in the drop-down list at the bottom.