Filter
Top Products
Administrating the Camera
Configuring the System — System Menu
34
Tips
• You can switch Iris open on the camera switch. For
details, refer to the supplied Installation Manual.
• For using the focus assist indicator, refer to the
supplied Installation Manual.
• When you reboot the camera, Iris open will
automatically switched to Off.
OK/Cancel
See “Buttons common to every menu” on page 28.
Initialize Tab
Display sample: SNC-DM160
Reboot
Reboots the camera.
Click Reboot, and the message “This Camera will be
rebooted. Are you sure?” appears. Click OK to reboot
the camera. It takes about two minutes to start again.
Factory default
Resets the camera to the factory settings.
Click Factory default, and the message “Setup data will
be initialized. Are you sure?” appears. When you click
OK, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
switch on the camera. For details, refer to the supplied
Installation Manual.
Backup setting data
Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera.
The file name preset at the factory is as follows:
SNC-DM110: snc-dm110.cfg
SNC-DS10: snc-ds10.cfg
SNC-DM160: snc-dm160.cfg
SNC-DS60: snc-ds60.cfg
SNC-CM120: snc-cm120.cfg
SNC-CS20: snc-cs20.cfg
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Then, click OK, and the camera is adjusted
according to the loaded data and restarted.
Notes
•With Restore setting, some items in the Network
menu (page 46) cannot be restored.
• The following items cannot be stored or restored with
Backup setting data or Restore setting.
– audio files uploaded using SNC audio upload tool
– a full image recorded in the camera (SNC-DM110 /
DM160 / CM120 only)
– a homepage created using Custom Homepage
Installer
– a client certificate and CA certificate to be used in
the 802.1X authentication function
Delete custom homepage
By pressing Delete, you can delete the homepage
recorded in the flash memory of the camera with
Custom Homepage Installer (page 89).
Capture full image (SNC-DM110 / DM160 /
CM120 only)
When you click Capture, a full image covering the
entire shooting range is shot and saved to the camera.
The full image is captured regardless of the image size
and crop settings.
Note
Main viewer image may be interrupted or image and/or
audio files may not be created correctly during image
capturing.
Delete image (SNC-DM110 / DM160 /
CM120 only)
By pressing Delete, you can delete the full image
recorded in the camera.