Filter
Top Products
17
DCR-DVD92E/DVD202E/DVD203E/DVD403E/DVD602E/DVD653E/DVD703E/
DVD803E 2-587-623-11 (1)
Step 2: Charging the battery pack
You can charge the battery after attaching
the “InfoLITHIUM” battery pack (P series)
(p.107) to your camcorder.
Mains lead
DC IN jack cover
To the wall socket
AC Adaptor
CHG lamp
DC plug
DC IN jack
Battery
Power switch
1 Slide the battery pack in the
direction of the arrow until it
clicks.
2 Slide the POWER switch in the
direction of the arrow to set it to
OFF (CHG) (The default setting).
3 Connect the AC Adaptor to the
DC IN jack on your camcorder.
Open the DC IN jack cover to connect
the AC Adaptor.
DC IN jack cover
Match the mark
on the DC plug with
mark on your
camcorder.
4 Connect the AC Adaptor to the
wall socket using the mains lead.
The CHG (charge) lamp lights up and
charging starts.
5 The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor
from the DC IN jack on your
camcorder.
Disconnect the AC Adaptor holding
both your camcorder and the DC plug.
Getting Started