Filter
Top Products
Getting started
14
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (P series) to
your camcorder.
b Note
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (P series) (p. 130).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall outlet when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
outlet immediately if any malfunction occurs.
1 Lift up the viewfinder.
2 Attach the battery pack by sliding it in
the direction of the arrow until it
clicks.
3 With the b mark on the DC plug facing
the LCD panel side, connect the AC
Adaptor to the DC IN jack on your
camcorder.
4 Connect the power cord to the AC
Adaptor.
5 Connect the power cord to the wall
outlet.
To the wall outlet
DC IN jack
Battery pack
Power cord
AC Adaptor
DC plug
b mark