Filter
Top Products
90
Access error.
• An error occurred during reading or
writing the hard disk of the camcorder.
Management file damaged. Create
new file?
• The image management file is damaged.
When you touch [YES], a new image
management file is created. When a new
management file is created, the old
recorded images on the hard disk of the
camcorder cannot be played back.
(Image files are not damaged.)
In this case, copy the image files to
computer by following the steps in
“Copying images to a computer” in
“Computer Application Guide”.
Buffer overflow
• The drop sensor senses a drop of the
camcorder, and you may not record the
image. Set the drop sensor to [OFF], and
you may be able to record the image
again.
Recovering data Avoid any
vibration.
• Your camcorder tries to recover data
automatically if the data writing was not
performed properly.
Cannot recover data.
• Writing data onto the hard disk of the
camcorder has failed. Attempts were
made to recover the data, but they were
unsuccessful.
x PictBridge compliant printer
Check the connected device.
• Turn off the printer and on again, then
remove the USB cable (supplied) and
reconnect it.
Connect the camcorder to a
PictBridge compatible printer.
• Turn off the printer and on again, then
remove the USB cable (supplied) and
reconnect it.
Error. Cancel the task.
• Check the printer.
Cannot print. Check the printer.
• Turn off the printer and on again, then
remove the USB cable (supplied) and
reconnect it.
x Flash
Charging... Cannot record still
images.
• You are trying to record a still image
while the flash is charging.
Flash cannot charge. Not available.
• A malfunction has occurred with the
strobe and disable charging.
Lens accessory attached. Cannot use
flash.
• The flash does not work when attaching
the conversion lens (optional) or filter
(optional).
x Lens cover
Lens cover not fully open. Turn power
off then on. (p.19)
Lens cover is not closed. Turn the
power off once. (p.19)
Warning indicators and messages (continued)