Filter
Top Products
masterpage:Right
filename[G:\_Upload\3073074111\307307411MVCFD100UC\02GB-
MVCFD100UC\09add.fm]
91
model name1[MVC-FD100/200]
[3-073-074-11(1)]
Additional information
Your computer does not
recognize your camera.
• The battery level is low.
t
Use the AC power adaptor (page 13).
• The camera is turned off.
t
Turn on the camera.
• The USB cable is not connected firmly.
t
Disconnect the USB cable, and connect it again
firmly. Make sure that “USB MODE” is
displayedontheLCDscreen(page30).
• The USB connectors on your computer are
connected to other equipment besides the keyboard,
the mouse, and your camera.
t
Disconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
• The position of the MS/FD selector is not set to the
proper position for the media being used.
t
Set the MS/FD selector to the proper position.
• The USB driver is not installed.
t
Install the USB driver (page 29).
• For Windows 98, Windows 98SE, Windows
2000andWindowsMeusers
Since the camera is connected to a computer using
the USB cable before installing the USB driver, the
drive is not recognized properly by the computer.
t
Delete the drive which is not recognized
properly, then install the USB driver. For details,
see the procedure on page 33.
Battery packs
Symptom Cause and/or Solution
The battery pack cannot
be charged.
• The power of the camera is turned on.
t
Turn off the power of the camera (page 10).
The battery life is short. • You are recording/playing back images under
extremely cold temperatures.
• The battery pack is not charged enough.
t
Charge the battery pack fully.
• The battery pack is dead.
t
Replace the battery pack with a new one.
Symptom Cause and/or Solution
01cov.book Page 91 Thursday, November 29, 2001 1:20 PM