Filter
Top Products
Switch the mecablitz to TTL mode. If necessary,
deactivate the controller function (only with Metz
TTL Remote Mode) and the secondary reflector.
4. Program auto flash mode
only DCS -V1, -V2, -F828
In the Program Auto Flash Mode the camera auto-
matically controls the aperture, the shutter speed
and the mecablitz in such a manner that optimum
results are achieved with mecablitz flashes in most
shooting situations, also in the fill-in flash mode.
Settings
Camera:
Select the Program AE Mode (camera sym-
bol) or SCN on your camera. Under SCN
you have the choice of TWILIGHT, LANDS-
CAPE or PORTRAIT. Now choose either Auto
Flash or Enforced Flash (see operating
instructions for the given camera).
mecablitz: Set the TTL Flash Mode on the meca-
blitz.
SCA 3602: Move switch ባ to the position GN. The
position of switch ቢ is B.
5. Functions of mecablitz and camera
5.1 Flash readiness indication
When flash readiness has been reached, the flash-
ready indicator on the flash unit lights up and the
flash unit transmits a corresponding signal to the
adapter or camera.
The indicator lamp for flash recycling on the came-
ra goes out. The flash unit will not be triggered if a
picture is shot before the indicator lamp goes out,
with the result that the shot may be underexposed.
14
705 47 0025.A2-GB,I,E 20.02.2008 15:48 Uhr Seite 14