Filter
Top Products
Adjustments Technical Manual LDK 20(S) - Studio Camera 4-5
Video Processor 1 Board
Setting-up the Camera
Note:
Video Processor 1 must be adjusted in combination with the Sync./Shading board.
1. For local powering of the camera in the stand-alone mode (see User Guide, Section 4).
2. Recall Factory Standard File on MCP or OCP.
On MCP set:
OPERATE MENU
Knee : Off
Contour : Off
Gamma : Lin.
Blk. Str. : Off
Auto Iris : Off
SETUP 1 MENU
Studio mode: Off
Flare : Off
White clip : Off
SETUP 2 MENU
Soft cont. : Off
SETUP 3 MENU
Skin cont. : Off
SETUP 4 MENU
Notch : Off
Chroma : Off
Asp. Ratio : 4:3
SETUP 5 MENU
Matrix sel. : 1:1
MAINT. 1 MENU
Wh. shading: Off
Oscilloscope: 10mV/div. probe 10:1
3. Put Video Processor 1 on a service extender.
4. Remove jumpers 7, 9, 11, 13, 17 and 19 from connector B of the service extender to interrupt the input from
the front and jumpers 6, 12 and 15 to interrupt the black shading correction.
5. Short circuit the input to video processor 1 by connecting the following jumpers on connector B of the service
extender:
B7 to B9
B11 to B13
B17 to B19