Filter
Top Products
II Technical Manual LDK 20(S) - Studio Camera 02.34.5
About This Manual
Service policy
The LDK 20(S) is a sophisticated camera containing
state-of-the-art electronic components which are
designed to provide long-life operation without the
need for maintenance. With this in mind, the service
policy of Thomson Multimedia Broadcast Solutions
endeavours to ensure that help will be quickly on hand
in the unlikely event of anything going wrong. The
guiding principles of the Thomson Multimedia Broadcast
Solutions first line maintenance philosophy are speed
and cost effectiveness. First line maintenance is
dedicated to keeping your camera operational, despite
a fault, by module replacement and the replacement of
minor mechanical parts by the user.
Purpose of this manual
The provision of correct information is the first step in
ensuring the operational integrity of the camera.
Information on the operation of the camera is to be
found in the User’s Guide.
This installation and first line maintenance manual is
an integral part of the service policy. It ensures that
you will be able to install and set-up your camera to
meet the requirements of your environment. This
information on the installation of the camera is contained
in Section 2 of the manual. The remaining sections of
the manual provide first line service information so that
suitably qualified service personnel can detect and
repair faults, normally by module replacement.
Because of the complexity of some of the components,
second line service can only be carried out at the
specially equipped service centres and information
concerning second line maintenance is not supplied
in this manual.
Intended audience
The manual is intended as a guide to those with a
working knowledge of camera systems and installation
techniques. The first line detection and repair of faults
requires a general knowledge of test and measurement
techniques.
Structure of this manual
The manual is divided into five sections:
Section 1: Safety Information.
Contains important safety information and should be
read before carrying out any work on the camera.
Section 2: Installation.
Gives instructions on the integration of the camera into
the operating environment and the customization of
certain hardware functions
Section 3: Replacements.
Gives information on the replacement of components
at first line level.
Section 4: Adjustments.
Contains the adjustment procedures to be followed to
obtain the best performance from the camera.
Section 5: Drawings.
Contains block diagrams of the camera.