Filter
Top Products
7.3.1. Camera Address Setting Switch (DIP Switch 1: No. 1 – 8)
Used to set camera address when using the camera in connection with the C-RM500 Remote Controller. Set
the DIP switch so that the address is equal to the connected switcher's channel number. The relationship
between switch settings and camera addresses are shown on page 14. (Factory setting: Only No.1 is “ON”.)
Note
If the address switch number does not match with the connected switcher's channel number or if set to the
same number as that of other camera connected to the same system, the system does not operate correctly.
12
DIP SW1
DIP SW2
DIP SW3
Note
Set the unused DIP switches to the "OFF" position.
If the DIP switches are not set correctly, the camera does not operate correctly.
DIP SW1 DIP SW2 DIP SW3
No.1
No.2
No.3
No.4
No.5
No.6
No.7
No.8
Camera address setting switch 1
Camera address setting switch 2
Camera address setting switch 3
Camera address setting switch 4
Camera address setting switch 5
Camera address setting switch 6
Camera address setting switch 7
Camera address setting switch 8
Communication speed setting
switch 1
Communication speed setting
switch 2
OSD switch
Unused
Unused
Unused
Unused
Unused
Unused
Unused
Communication method selector
switch
Termination switch
Firmware update switch 1
Firmware update switch 2
Firmware update switch 3
Memory clear switch
7.3. Dip Switch Settings