Filter
Top Products
- 33 -
Camera Address = 1 × bit 1 Status + 2 x bit 2 Status + 4 × bit 3 Status + 8 × bit 4
Status + 16 × bit 5 Status +32 × bit 6 Status + 64 × bit 7
Status + 128 × bit 8 Status
* bit Status: On = 1, Off = 0
ex) Camera Address 228 = 1 × 0 (Off) + 2 × 0 (Off) + 4 × 1 (On) + 8 × 0 (Off) + 16 × 0
(Off) + 32 × 1 (On) + 64 × 1 (On) + 128 × 1 (On)
=4 + 32+ 64 + 128 + 228 → Off/Off/On/Off/Off/On/On/On
Set up the protocol and bit rate to match the controllers settings.
(2) SW2 (bit 1 - 2) Protocol
bit1
Off
On
Off
On
bit2
Off
Off
On
On
TOSHIBA-P
TOSHIBA-D
Reserve1
Reserve2
Protocol
(3) SW2 (bit3 - 4) Bit Rate
bit3
Off
On
Off
On
bit4
Off
Off
On
On
1200bps
2400bps
4800bps
9600bps
Protocol
(Dome base switch:S301)
This is RS422 termination switch located near the BNC connector.
In daisy chain operation system, the farthest dome from the controller is turned ON.
For example, when the controller is connected with three dome cameras in the direct mode,
the only furthest dome camera from a controller is turned ON. The other dome camera is
turned OFF. (It is OFF at the time of shipment.)
ON and OFF are as in a figure.
ON
S301
OFF
BNC Connector
POWER
TERMINAL