Filter
Top Products
26
¾ Use the following IP address: Select this when the fixed IP address is set.
z IP address: Enter the IP address of the device.
z Subnet mask: Enter the subnet mask.
z Default gateway: Enter the default gateway.
¾ Use the following DNS server address: Select this when you set the fixed IP address as the
IP address of DNS server.
z Primary DNS server: Enter the IP address of the primary DNS server.
z Secondary DNS server (optional): Enter the IP address of the secondary DNS server if
necessary.
¾ HTTP port number: Select 80 in general situations. If you want to use a port number other
than 80, select the text box and enter a port number between 1024 and 65535.
z When you have set the HTTP port number to a number other than 80 on the Network
setting page or in the Setup Program, access the device by typing the IP address of the
device on the web browser as follows: for example, when HTTP port number is set to
2000, you should type in http://192.168.1.100:2000/
to access the device.
The change of settings will not take effect until the camera is rebooted. Please go to
“SETTING→ BASIC → System → Initialize” page and click the Reboot button as shown in
the figure below after you make some changes.