Filter
Top Products
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP302PI
30
Area Setting: Click Area 1 /Area 2/Area 3 icon then draw the motion detection
area on the live screen. If there is any motion detected in these areas, the
"Motion!" wording will show on the live screen. To clean the motion detection
area, click Area 1 /Area 2/Area 3 icon again.
Sensitivity: Select motion detection sensitivity from 1 to 10.
Trigger Action (Area 1, Area 2, Area 3): When motion is detected, the camera
can send video or snapshot to Email, FTP, Output device and Samba.
Subject: This subject will appear as the subject when sending the motion
detected video or snapshot to email.
Interval: Each motion triggered in defined interval time. If you select "10 sec"
here, once the motion is detected and action is triggered, the next motion will be
trigger after 10 seconds. .
Based on the schedule: The motion detection will be triggered based on the
schedule you define.
Event Configuration >> Motion Detection >> Record File
When an event happens, the IP camera can record a video clip or take snapshot, and
then send the file to mail/ FTP/ Samba. Select what format you want to save.
AVI File (with Record Time Setting): Save AVI video file. The video length is
according to the value you set in Record Time Setting.
JPEG File (Single File with Interval Setting): Save single JPEG picture file when
event happens.
JPEG Files (with Record Time Setting): Only when you select "JPEG" in streaming
1 video format of Video Setting, this option can be enabled. Select this option to
save several JPEG picture files, and the successive picture files cover a period of
time according to the value you set in Record Time Setting.
Event Configuration >> Motion Detection >> Record Time Setting
When a event happens, the IP camera can record a video clip or take snapshot, and
then send to mail/ FTP/ Samba. Select the video recording length before and after
event happens.
Event Configuration >> Motion Detection >> Network IP Check
Enter the target IP address and interval. The camera will base on the interval time to
check the target IP address. If PIN failed 4 times, the camera itself will reboot.