Filter
Top Products
11
TV-IP522P ProView Me
g
a
p
ixel Internet Camera
2
Installing the Camera
The camera should be attached to the stand included in the package. The camera stand can be
mounted on a flat surface using the three screw holes on the base of the stand. The camera is
intended for indoor use. The camera, the power adapter and power source should be protected
from water and moisture, excessive heat, direct sunlight and cold. Make sure the power adapter
and cord and Ethernet cable are safely arranged so they do not create a tripping hazard and will
not be disturbed by people or objects moving past.
Attach Camera to Stand
Determine the location for the camera and assemble the camera stand. Secure the stand to the
flat surface or ceiling with the mounting screws included in the package. When the stand is
assembled and firmly attached to flat surface or ceiling, attach the camera. Do not attach
network cables or the power cord until the camera is firmly mounted in place.
Follow the assembly and installation instructions below to mount the
camera before connecting the power or network cables.
1. Determine where the camera will be located and assemble the camera stand. For wall
mounting, use both arm sections of the camera stand. For ceiling or flat top surface
mounting, use the straight section of the stand only.
2. Firmly attach the camera stand to a suitable flat surface by placing screws in the holes of the
mount plate and screwing them into place. Make sure the stand is securely attached before
attaching the camera.
3. Aim the camera at the area of coverage and hand tighten the nut to keep the camera in
position.
4. Attach the Ethernet cable (see below).
5. Attach the power adapter and connect it to a suitable power source (see below). Check
the power and Ethernet LED indicators to check for basic functionality.
The camera is shipped with a camera stand. The swivel ball screw head on the stand can be
attached to the bottom screw hole of camera. The swivel ball mount allows the camera to be
pointed in a direction and fixed in position. Three holes on the base of the
camera
stand
are used
to securely attach the stand to a wall or ceiling.