Filter
Top Products
49
http://www.tyan.com
Install driver manually
Control Panel->Add Hardware
Select “No, I have already connected the hardware”
Select “add a new hardware device”
Select “Install the hardware the I manually select from a list”
Select “System Devices”
Select “Have Disk”
Select “Browse”
Select file “imbdrv.inf”
Linux:
M3291 can use the OpenIPMI driver in Linux Kernel. But as M3291 KCS port is
CA8:CAC, version V33 is needed.
modprobe ipmi_devintf
modprobe ipmi_si
If “ipmi_si” module load fail, you can try to add parameter:
modprobe ipmi_si type=kcs ports=0xca8 irqs=0 regspacings=4
Question: How can I use SMDC function before OS is installed and running?
Solution: Follow the steps below:
1. Connect the AC power.
2. Boot the system into BIOS and shutdown the BIOS – this step only need to be done
once after one SMDC is installed in the mainboard, and SMDC needs the information
of MAC address from mainboard.
3. Install the TSO manager and TSO console correctly in client machine.
4. Start TSO console and use Tool/Discovery setting to make sure the SMDC
discovery is enabled (including broadcast discovery).
5. All systems with SMDC installed will show up. Correctly set the IP address.
6. Now you can use the Power/Off and other SMDC functions
Question: How to set console redirection SOL in BIOS?
Console redirection Serial Over Lan need BIOS support
1. BIOS Advance setting,
a. COM port B
b. Baud rate 19200
c. VT100
d. RTS/CTS
e. After POST ,always on
Question: How to set linux Text mode SOL display?
Please refer to /user/src/Linux-2.4/Documentation/serial-
console.txt for detail.
1.boot kernel message showing:
/etc/lilo.conf
#put this line under message=/boot/message