Viking Access Systems H-10 Photo Scanner User Manual


  Open as PDF
of 50
 
VIKING TECHNICAL SUPPORT 1.800.908.0884
37
TROUBLESHOOTING
LED References
Use the table below to identify the corresponding “TS Ref#” and refer to page 38-41 for
further troubleshooting.
# LED Status Meaning
Pg 41
TS Ref#(s)
9 “C Loop” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
C Loop terminal (pgs 32, 42).
9, 10
10 “Open” OFF Normal Condition.
SOLID Control board is receiving an input for a device connected to any of
the following input terminals: Exit, Fire, Strike or Open (pgs 31, 42).
9, 10
11 “STOP” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
Stop terminal (pgs 31, 42).
9, 10
12 “Close” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
Close terminal (pgs 31, 42).
9, 10
13 “Siren”
OFF Normal Condition.
SOLID Second consecutive obstruction has been detected. (pg 26).
11, 13, 1, 2
FLASHING Batteries are critically low.
1, 2
14 “Aux. Pwr”
OFF No voltage output on these terminals at the moment.
SOLID There is 24v DC output on these terminals at the moment.
15 “Diagnose” OFF Normal Condition.
FLASHING Errors have been detected; Check LCD Display for ERR messages (pg 40).
16
“Close Limit”
OFF Gate is not at the close limit position.
SOLID Gate is at the close limit position.
FLASHING Close limit position has been erased or not set (pg 20-21).
6
17
“Open Limit”
OFF Gate is not at the open limit position.
SOLID Gate is at the open limit position.
FLASHING Open limit position has been erased or not set (pg 20-21).
6
18 “ODS” OFF Normal Condition.
SOLID Obstruction has been detected. (pg 26).
11, 13, 1, 2
FLASHING Overload has been detected. (pg 26).
11, 13, 1, 2
19 “Timer” OFF The close timer is turned OFF or gate is not at the open limit if the timer is
turned ON. (pg 24).
SOLID Gate is at Open Limit, Timer is turned ON and counting down to close. (pg
24).
FLASHING Gate is at Open Limit, Timer is turned ON but is not timing out due to a
conictingcommand.(pg24).
9, 10
20
“AC VOLTAGE INPUT”
SOLID Normal Condition.
OFF IncomingpowertoPowerSupplyPanelAssemblyisnotsufcient.(pg18).
1
21
“PROTECTION WORKING”
SOLID Normal Condition.
OFF EMI Board is damaged and circuit is not protected . Replace EMI Board.
22
“AC VOLTAGE OUTPUT”
SOLID Normal Condition.
OFF There is no output voltage from the Power Supply Panel Assembly.
2
23 “AC POWER” SOLID Normal Condition for High Voltage installations.
OFF High Voltage is not supplied to the Modular Power Box (pg 18).
1
 previous next