Filter
Top Products
VIKING TECHNICAL SUPPORT 1.800.908.0884
39
TROUBLESHOOTING
LCD Display References
LCD MSG Meaning
Page 41
TS Ref #s
Multi Meter Displays
MOT AMP
__._ A
This is the motor current amperage during operation
MOT VOLT
__._ VDC
This is the actual motor voltage during operation
AC VOLT
__._ VAC
This is the actual low voltage AC to the Control Board from the transformer
CHARGE
__._ VDC
Indicates the charging voltage to the batteries, if the Battery Switch is in
the OFF position.
BAT VOLT
__._ VDC
Indicates battery voltage, if the AC power is discontinued to the Control
Board.
Board Settings Messages
EPS2
___% ERR
Indicates that the Electronic Positioning Sensor (EPS) needs to be tuned.
Error rate is displayed as a percentage
Speed
__%
Shows the percentage of speed set by the Speed adjustment on the control
board. (pg. 24)
OVERLAP
_._ SEC
Shows the number of seconds set by the Overlap Adjustment on the con-
trol board. This feature is not available on slide gate operator models
ODS SENS
___%
Shows the force setting selected to trip the obstruction sensor. (pg. 26)
TIMER
__ SEC
Shows the amount time set or remaining to hold the gate at the Open Limit
position, before the gate starts to close. (pg. 24)
HEATER
__ OFF
The Integrated Heater is disabled for the open “OPN” and/or close “CLS”
limits (pg. 27)
HEATER
__ ON
The Integrated Heater has been enabled to turn on at the open “OPN” and/
or close “CLS” limits (pg. 27) “*” will be displayed while it is heating
LOCK MOD
OFF
The Lock Mode feature is turned OFF (pg. 27)
LOCK MOD
ON
The Lock Mode feature is turned ON (pg. 27)