Filter
Top Products
Taking a Picture
5
Taking a Picture
Using the Capture mode on your camera, you can:
♦ Take a picture
♦ Preview the picture on the LCD display before taking it
♦ Instantly review and (if you don't like what you see) delete the picture just taken
To select this mode, slide the Mode switch to the position labeled “Capture”.
Powering the Camera On/Off
To turn the camera on:
1 Press the Power button.
2 Wait until the Ready light on the back of the camera stops blinking and turns a solid, steady green.
è The camera is now ready to take pictures.
To turn the camera off:
Press the Power button again.
è The camera will preserve all preference settings (adjustments) made prior to turning it off.
Note: When the camera is powered off, your settings will be retained. However, if you remove or replace
the batteries the camera will loose the current settings and the camera will revert to the factory default
settings.
Using power-save:
Your camera contains a power-saving feature that automatically turns the camera off after three (3) minutes
of inactivity or after five (5) minutes of inactivity when the camera is connected to a computer.
If you are using the LCD to preview pictures while the camera is powered by batteries, the camera will shut
off after 30 seconds of inactivity. You can extend this time interval to 3 minutes by holding down the
Select button for 2 seconds when starting LCD preview mode.
è To restore power to the camera after it has automatically turned off, press the Power button.
è To adjust the time interval of the power-save function, see the Image Expert User’s Guide.