Version 1.2 Page 8 4/22/04
Select Active Standard Error Devices
Cold Reset
Exit
Timeout-->[10] sec SystemGuid-->[C198BA79-478A-11D7-9C22-
6033AC66036B]
SerialNumber-->[US30464638 ]
Step 3
Select each of the consoles and set the active console device. Use either "v" "^" or !
". For this example, we will change only the console output device. When you select
the output device, you receive a display something like the one below:
EFI Boot Maintenance Manager ver 1.10 [14.61]
Select the Console Output Device(s)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(VtUtf8)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(PcAnsi)
* Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(VtUtf8)
Acpi(HWP0002,700)/Pci(2|0)
Save Settings to NVRAM
Exit
Step 4
Using either the "v" "^" or ! ", move to the device you want to select or deselect.
Pressing the Space bar changes the state, and the asterisk (*) indicates what is
selected. In the above list, the Management Processor is selected and set to emulate a
VT100. If you select Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100), the
console is the BMC console labeled as console/serial A on the back of the system.
Step 5 After making your changes, select the "Save Setting to NVRAM" and then exit.
Step 6 Repeat Steps 4 and 5 for the output and error devices.
Step 7 Finally, perform a cold reset of the system. If you changed the console from MP to
the BMC or vice versa, you may need to move the serial cable to the appropriate
connector on the system.
