2–2 HP Integrity rx2600 server and HP workstation zx6000 Getting Started Guide
Troubleshooting
your system does not start properly
The system doesn’t power on.
Make sure... How
The system’s power cord is properly
connected.
Connect the power cord to a working power
outlet and to the rear of the system.
There is a buzzing noise.
A beep code when the system starts up means that there is a configuration problem. Many of the
e-buzzer codes relate to the LED diagnostic codes. See section “Using the LEDs and e-buzzer to
Troubleshoot Your System.”
Make sure... How
You identify the error message correctly. Count the number of beeps after the buzzer (see
“Troubleshooting with the e-buzzer” on
page 2-10). Contact HP Support (see
page 2-19).
If you still have a problem, see “Software Diagnostics Tools” on page 2-13.
lp0103gs.book Page 2 Tuesday, June 8, 2004 4:42 PM
