Helix 11
GB
Control Panel
4.1 Block Heater Control
Refer to item 8 in section 4. The block heater control
regulates the temperature of spray material as it
passes through the heater block, prior to it reaching
the heated hoses.
1
EZ-ZONE
ºF
ºC
Z
O
N
E
8.8:8.8
8 8.8:8.8
EZ
2
1
3
4
5
1 Temperature
display
Shows actual temperature of the heater
block.
2 Programming
buttons
These are non-functioning factory
programming buttons. Do not use.
3 Power
indicator
Theashingorsteady“1”indicatessucient
powerisbeingdeliveredtothesystem’s
electrical relay.
4 Temperature
setting
Shows the desired temperature of the heater
block set by the operator
5 Temperature
adjustment
These buttons will increase ( p) or decrease
( q ) the temperature of the heater block.
The temperature will change in increments
of 1ºF. Press and hold the button to increase
the increments by 1ºF and then 10ºF.
Refer to section 8.2 to review the controller error
messages.
4.2 Heated Hose Temperature Control
Refer to item 1 in section 4. The heated hose
temperature control maintains the temperature of
the spray material once it passes through the heater
block and into the heated hoses.
1
EZ-ZONE
ºF
ºC
Z
O
N
E
8.8:8.8
8 8.8:8.8
EZ
2
1
3
4
5
1 Display Displays the current temperature of the
heated hose set
2 Programming
buttons
These are non-functioning factory
programming buttons. Do not use.
3 Power
indicator
Theashingorsteady“1”indicatessucient
powerisbeingdeliveredtothesystem’s
electrical relay.
4 Temperature
setting
Shows the desired temperature of the
heated hoses set by the operator
5 Temperature
adjustment
These buttons will increase ( p) or decrease
( q ) the temperature of the heated hose set.
The temperature will change in increments
of 1ºF. Press and hold the button to increase
the increments by 1ºF and then 10ºF.
Refer to section 8.2 to review the controller error
messages.
Decreased voltage under 230V AC may increase
initial heat time.
