Titan Tool 138010 Manual

A SERVICE OF

next previous

Helix 17

GB

Setup Operation

6. Operation

Attention

Prior to startup, make sure the generator has fuel.

Running out of fuel will cause electrical uctuations

in the system that could result in damage to the

electrical components of the system.

6.1 Startup

1. If using a generator, make sure the main breaker on the

generator is in the OFF position.

2. If using a generator, start the generator. Allow it to run to full

power.

3. If using an air compressor to power the transfer pumps, start

the compressor, making sure the bleed valve is in the closed

position on the compressor.

 4. TurnthebreakeronthegeneratortoON.Switchbothofthe

ComponentPumpON/OFFswitchestoON.(thesearethe

outermostON/OFFswitcheslocatedonthecontrolpanel).

Attention

Do not turn on the block heater or hose heater ON/

OFF switches ON yet. Turning the hose heaters on

when there is no uid in the hoses can cause damage

to the hoses.

5. Turn the PRIME/SPRAY valves on both of the Component

Pumps to SPRAY.

6. Open the uid inlet valves. Check for leaks.

7. Place the coupling block (with hoses attached) over two

separate, grounded waste containers. Make sure the ports on

the manifold each aim into a dierent container.

NEVER mix components A and B during startup. Use

two separate grounded waste containers to keep

Component A and Component B separate.

9. While holding the coupling block over the waste containers,

slowly open uid valves A then B. Allow them to remain open

until clean, air-free uid comes from the valves.

10. Close uid valves A then B.

6.2 Set temperature

i

Refer to section 4. to review temperature controls.

Equipment surfaces can become hot. To avoid

severe burn injury:

1) Do not touch hot uid or equipment.

2) Allow equipment to cool completely before

coming into contact with it.

3) Wear gloves when dealing with temperatures

in excess of 110ºF (43ºC)

 1. Setthetemperatureoftheheaterblock:

 a. SwitchtheheaterblockON/OFFswitchtoON(thisistheON/

OFF switch in the middle of the control panel).

b. Using the heater block controls, set the heater block to the

desired temperature. Press the (

p)

button until the bottom set

of numbers (1) shows the desired temperature.

1

EZ-ZONE

ºF

ºC

Z

O

N

E

65

8 110

EZ

13

2

i

The top number (2) on the heater block displays the

actual temperature. When the light (3) goes out, the

block heater is suciently heated.

2. Set the temperature of the heated hoses (repeat each of the

followingstepsforbothAandBhoses):

 a. SwitchtheheatedhoseON/OFFswitchestoON(thesearethe

switches immediately on either side of the heater block switch

in the middle of the control panel).

b. Using the heated hose controls, set the heated hoses to the

desired temperature. Press the (

p)

button until the bottom set

of numbers (1) shows the desired temperature.

c. The temperature settings of the heated hoses can also be

adjusted to balance spraying pressures as well as the desired

ViscosityCompension(Vis-Comp).

i

Adjusting the hose heat should ONLY be a secondary

method of achieving the correct Vis-Comp. Use the

Vis-Comp Screen on the Control Display rst.