3Com DSA-3CV1001-02 Manual

A SERVICE OF

next previous

Installing the VCN Access Point 33

To mount the VCN AP on top of a table perform the following tasks:

1

Stick the four rubber pads to the bottom of the VCN AP as shown in

Figure 24

.

Figure 24 Preparing VCN AP for Table Top Use

2

Turn the VCN AP over and place it on top of a table near the ac power

and telephone sockets in the room.

Connecting the VCN

AP

To enable VCN AP operation, connect the following from the rear of the

unit:

■ Connect the RJ-11 cable coming out from the telephone set to the

VCN AP PHONE port at the front.

■

Connect an RJ-11 cable from the VCN AP LINE port to the wall

telephone socket.

■

Connect the ac/dc adapter to the DC-IN port in the VCN AP and to the

ac power socket in the room.

The resulting connections are illustrated in Figure 25

.

Local

Management

Section

Rear

Panel

Attach Four Rubber Pads