VCN Access Point Menus 45
Reset Counters
To reset Ethernet counters:
1
In the
Ethernet Menu
, type
3 and press <Enter>. The following message
appears:
Do you want to proceed (Y/[N])? :
2
Ty p e
y and press <Enter> to perform the reset. The following message
appears:
The action has been done !
Learning Table
To view the MAC and IP addresses of the user’s PC, type
5 in the
Ethernet
Menu
and press <Enter>. If a PC is connected, the
Learning Table
in
Figure 36
appears.
Figure 36 A Typical MAC Address Display
If a PC is not connected, the message in Figure 37 appears.
Figure 37 Station not Connected Message
Change Ethernet Work Mode Menu
To change the Ethernet loopback mode or the duplex mode, use the
Change Work Mode Menu
. In the
Ethernet Menu
, type
4
and press
<Enter>. The options in Figure 38
appear.
Learning table:
---------------
MAC address: 00-60-08-BC-F7-7F
IP address : 191.28.68.25
Press <Enter> to continue.......
Learning table:
---------------
Station not connected
press <Enter> to continue...
