Filter
Top Products
8
AgfaPhoto
DV-5000Z
Loading the Battery
To load the battery into the camera:
1. Position the camera with the lens facing you and open the battery / SD card
compartment by pressing the cover and sliding it towards you. The cover
door will snap open.
2. Turn the battery so that the label is facing to the right and the three gold
contacts on the battery are positioned upwards and to the rear of the camera.
The side of the battery with the three gold contacts will slide directly into the
battery compartment first.
3. Slide the battery into the compartment until fully inserted.
4. Close the battery / SD card compartment by pressing down on the cover and
sliding it towards the rear of the camera. The cover will snap shut.
To remove the battery, open the battery / SD card compartment and push the
battery compartment clip upwards; then slide the battery out of the
compartment.
Note: You do not need to remove the battery for charging but you may
need to remove the battery to replace it in the future.
Charging the battery
Before you can operate your Digital movie camera, the included battery needs
to be charged for 6 hours without interruption.
1. Make sure your battery has been
fully inserted with the Battery / SD
Compartment door shut. Refer to
"Loading the Battery." Additionally
you may want to ensure that the
SD card has been inserted. (For
more information, please read
"Inserting the SD memory card.")
2. Carefully open the protective
rubber cover below the main
controls of the camera with your
thumb or finger.
3. Connect the power adapter cord
to the camera and the transformer
plug to a power outlet.
4. Charging should commence and
the charging indicator LED will
light red. When charging is
finished you will see that the charging indicator has turned green. At this point
you may safely disconnect the power adapter cord and the transformer plug
and use the camera.
5. Charge the battery for 6 hours for the initial charge or charge for 1 hour if
subsequently recharging the battery.