Filter
Top Products
ENGLISH
19
To stop recording
Press s STOP.
To pause recording
Press a PAUSE/STILL. “RECP” appears on the TV screen.
To resume recording, press a PAUSE/STILL again.
To prevent an accidental recording
Break off the erasure prevention tab on the back edge of the
cassette.
To record over the tape again, cover the gap with adhesive
tape.
To watch another TV program while
recording
Press TV/VCR after starting the recording so that “VCR” in
the display window disappears. Then select another channel
on the TV.
To monitor the recording, set the channel on the TV to that
of the CHANNEL selector, and press TV/VCR again.
Tips
• If you want to record the program through the line input,
press 0/INPUT,CHANNEL i, k on the remote control,
CHANNEL N or M on the VCR continuously to display
“LINE1” (from AUDIO/VIDEO IN jacks at the rear) or “LINE2”
(from the AUDIO/VIDEO IN jacks in the front) in the display
window in step 3.
• To start recording during playback, press a PAUSE/STILL,
and w REC/ITR, then a PAUSE/STILL.
Notes
• If you try to record on a cassette without its erasure
prevention tab, the VCR will eject the cassette.
• If recording pause lasts for more than 5 minutes, the VCR
will automatically enter stop mode to protect the tape.
• When using the 0/INPUT button to select the input channel,
press 0/INPUT twice.
• The channel cannot be changed during recording.
Recording a TV program
Before starting
• Turn on your TV and see it for the VCR reception.
• Set the VCR /CATV/DBS/ TV selector to VCR.
Insert a cassette with its erasure prevention tab
in place.
The power turns on automatically.
Press SPEED to select the tape speed, SP or
EP.
EP provides three times as much recording time as SP,
although SP produces better picture and audio sounds.
1
2
3
4
RECORDING
Number
buttons
STOP
SP
Erasure prevention tab
Adhesive tape
VCR /CATV/DBS/ TV
sSTOP
aPAUSE/STILL
CHANNEL i/k
SPEED
0/INPUT
OTPB
wREC/ITR
ONE-TOUCH PLAY BACK
TV/VCR
CHANNEL
N/M
wREC/ITR
aPAUSE/
STILL
sSTOP
Press CHANNEL i or k on the remote control,
CHANNEL N or M on the VCR, or number
buttons to select the channel to record.
If you use the number buttons, it will take a few seconds
after you have pressed the buttons for the channel to
change.
Press w REC/ITR to start recording.
“V.MARK” flashes on the TV screen when marking an
index signal.