American Dynamics ADCTDN0230P Security Camera User Manual


 
10
Introduction
Storage and Location of Use
This camera has been designed for indoor use. When you use it outdoors,
be sure to use a housing or the like.
Do not install or use the camera in the following places.
In a place exposed to rain or moisture.
In a place with vapor or oil, for example in a kitchen.
When the ambient temperature rises above or falls below the acceptable
range (from -10 I to 50 I)
In a place at which corrosive gases are emitted.
Near a source of radiation, X-rays, strong radio waves or magnetism.
In a place subject to vibration.
In a place with excessive dirt.
Using this unit or cables connected to this unit at places at which strong
radio waves and magnetism are emitted (e.g. near a radio, TV, transformer
or motor) may give rise to noises in the image and changes in its color.
Maintenance
Turn off the power before performing maintenance.
Clean the camera with a soft cloth. Wiping it with thinner or benzene may
melt the surface or cause it to fog. For tough stains, wipe using a cloth that
is dipped into a neutral detergent diluted with water, followed by wiping
with a dry cloth.
Energy Conservation
When the camera is not in use for a long time, turn off the power of the
system for safety and energy conservation reasons.
Operating Precautions
ADCTDN2412N_P_EN.book Page 10 Friday, September 28, 2007 12:49 PM