American Dynamics ADCTDN0230P Security Camera User Manual


 
3
16.
a. When the power cord or plugis damaged or frayed.
b. If liquid has been spilled into the appliance.
c. If the appliance has been exposed to rain or water.
d.
e. If the appliance has been dropped or the cabinet has been damaged.
f.
17.
18.
If the appliance does not operate normally by following the
operating instructions. Adjust only those controls that are covered
by the operating instructionsasimproper adjustment of other
controls mayresult in damage and will often require extensive work
by a qualified techniciantorestore the appliance to normal
operation.
13.
14.
15.
Never pushobjects of any kind into thisappliance through cabinet slots
as they maytouch dangerous voltage points or short outparts that
could result in a fire or electric shock. Never spill liquid of any kind on
the appliance.
Do not attempt to service thisappliance yourself as opening or
removing covers may exposeyou to dangerous voltage or other
hazards. Refer
all servicing to qualified service personnel.
Unplug thisappliance from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
When the appliance exhibitsadistinct change in performance - this
indicatesaneed for service.
When replacement partsare required, be sure the service technician
has used replacement partsspecified by the manufacturer thathave
the sa
me characteristicsasthe originalpart. Unauthorized
substitutions mayresult in fire, electric shock, or other hazards.
Upon completion of any service or repairs to thisappliance, ask the
service technician to perform routine safety checks to determine that
the appliance is in safe operating condition.
Do not overloadwall outletsand extension cordsasthis canresult in
fire or electric shock.
11.
12.
Follow all warningsand instructions marked on the appliance.
Do not allow anything to rest on the power cord. Do not locate this
appliance where the cord will be abused by persons walking on it.
ADCTDN2412N_P_EN.book Page 3 Friday, September 28, 2007 12:49 PM