Filter
Top Products
20
Setup
When you install in a place where noise tend to appear, please use a cable
with a shield. A shield cable should be connected to a GND terminal.
Memo:
● Turn off the power of devices to be used before connecting the cables.
● Read through the “Instruction Manual” of the devices to be used carefully
before connecting.
Connecting the back panel
CLASS 2 ONLY
ISOLATED POWER ONLY
SEE INSTRUCTION
MANUAL
POWER
VIDEO OUT
SELECTOR
SET
MENU
INT LL
+
1
2
DC12V d
AC24V H
GNDAUX
R
To the terminal of infrared illumination device etc.
(A Pg.22)
Monitor
Connect to AC 24 V or
DC 12 V power supply
(ADCTDN2412N/P)
Connect to AC 220
V-240 V power supply
(ADCTDN0230P)
ADCTDN2412N_P_EN.book Page 20 Friday, September 28, 2007 12:49 PM