Filter
Top Products
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available characters in
the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field.
Pan Left/Right
Move the highlight up or down in the character field.
Tilt Up/Down
Select the highlighted character in the character field.
A/P
Move the cursor to the right of the current character
in the name or password.
Pan Right (or Zoom In)
Move the cursor to the left of the current character in
the name.
Pan Left (or Zoom Out)
Setting Left and Right Auto Pan Scan Limits
IMPORTANT
You must program the Left Scan Limit setting before programming the Right Scan
Limit setting. This procedure erases any previously programmed Right Scan Limit
setting.
Programming the Scan Limits:
1. Select the camera number assigned to the SpeedDome Ultra VII dome.
2. Use the pan/tilt joystick to position the dome’s pointing direction to the Left Scan Limit.
3. Set Run/Pgm switch to Pgm.
4. Enter Set Preset 98 to save the setting.
5. Position the dome’s pointing direction, by panning right to Right Scan Limit.
6. Enter Set Preset 99 to save the setting.
7. Set Run/Pgm switch to Run.
Note: If both the Left and Right scan limits are set to the same position, the dome
continuously pans to the right when Auto Pan is activated.
F–4 SpeedDome Ultra VII Day/Night Operator's Manual