Filter
Top Products
Issue 8 February 2007 21
Chapter 7: Install Media and Expansion Modules
Note:
Note: In each gateway, a single expansion module can be installed in the lower left slot
only. If the S8300 is installed (in slot V1), up to 3 media modules can be installed
in slots V2–V4. If no S8300 is installed, a fourth media module can be installed in
Slot V1.
1. To install a media module, first remove
the upper right blank faceplate.
Note:
Note: All slots must have either a
module installed or be
covered by a blank face plate.
Do not leave any slots
uncovered.
2. Align the media module with the interior
guides and insert into slot until firmly
seated.
3. Tighten the captive screws.
4. Repeat steps 1 through 3 for each media
module to be installed.
5. To install the expansion module, first
remove the lower left blank faceplate.
6. Align the expansion module with the
interior guides and insert into slot until
firmly seated.
7. Tighten the captive screws.