Filter
Top Products
Dinion2X IP Camera Advanced Mode | en 101
Bosch Security Systems Installation and Operation Manual AR18-10-B006 | v1.1 | 2010.06
9.9 Interfaces
9.9.1 Alarm input
Configure the alarm triggers for the camera.
Select N.C. (Normally Closed) if the alarm is to be triggered by
closing the contact.
Select N.O. (Normally Open) if the alarm is to be triggered by
opening the contact.
Name
Enter a name for the alarm input. This is then displayed below
the icon for the alarm input on the LIVEPAGE (if configured).
Action
Select the camera mode to switch to when alarm input 1 is
triggered. See Section 9.8.8 Alarm Task Editor, page 100, for
information on alarm actions based on alarm inputs.
9.9.2 Relay
Configure the switching behavior of the relay output.
Select different events that automatically activate an output.
For example, turn on a floodlight by triggering a motion alarm
and then turn the light off again when the alarm has stopped.
Idle state
Select Open for the relay to operate as an N.O. contact, or
select Closed if the relay is to operate as an N.C. contact.
Select
Select External device or Motion+/IVA to trigger the relay.
Interfaces
> Alarm input
>Relay
>COM1