Filter
Top Products
Dinion2X IP Camera Camera set-up | en 41
Bosch Security Systems Installation and Operation Manual AR18-10-B006 | v1.1 | 2010.06
6.2.3 Network submenu
To operate the camera in your network, a network-valid IP
address must be assigned. The factory default IP address is
192.168.0.1
The new IP address, subnet mask, and gateway address are set
when leaving the menu. The camera reboots internally and the
new values are set after a few seconds.
6.2.4 Defaults submenu
Function Selection Description
IP Address Enter an IP address for the camera. Use
LEFT/RIGHT to change position in the
address, use UP/DOWN to select the digit.
Use SELECT to exit the address edit
screen.
Subnet
Mask
Enter the Subnet mask (default
255.255.255.0).
Gateway Enter a Gateway address.
DHCP If the network has a DHCP server for
dynamic IP address allocation, set this
parameter to On to activate the automatic
acceptance of DHCP-assigned IP
addresses.
Exit Return to the Install menu.
Item Selection Description
Restore All? No, Yes Restores all settings of the six modes
to their default (factory) values. Select
YES then press the Menu/Select
button to restore all values.
When completed the message
RESTORED! is shown.